Ariens 917012 Especificaciones descargar pdf (Pagina 12)

EN - 12

Control Level (Item 9)

(Figure 5)

The control lever is used to move the splitting

wedge in or out when operating in the

horizontal position or up and down when

operating in the vertical position.

Extend/Down – Move lever in this direction to

extend cylinder toward end plate. Keep

pressure on lever until log is split. Lever does

not lock in this position. Release as soon as

log is split or cylinder is fully extended.

NOTICE: Splitter wedge is designed to reach

full extension and stop 1 – 2" (25 – 50mm)

before contacting end plate.

IMPORTANT: When cylinder is fully

extended do not hold lever in out position.

Pump damage will result.

Neutral – In this position the cylinder does not

move even though the engine is running.

Return/Up – Move lever in this direction to

retract cylinder. Push lever fully in this

direction to lock in return mode. Lever will

automatically return to neutral once cylinder

fully retracts.

Beam Assembly Lock (Item 14)

Locks the beam in the horizontal operating

position. To move beam to vertical operating

position:

1. Pull beam lock out until the pin clears

the mount

(Figure 6).

2. Rotate beam lock slightly so pin does

not return to hole in mount.

3. Lift beam until it rotates to vertical

position

(Figure 7).

Figure 5

Horizontal Splitting

Vertical Splitting

Return

Extend

Neutral

Up

Down

Neutral

9

18

WARNING: Keep hands and

fingers away from splitter wedge

and stripper plates during cylinder

retraction.

CAUTION: Beam assembly is

heavy. Use care when moving

between vertical and horizontal

positions.

Figure 6

14

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Comentarios a estos manuales

Sin comentarios