Ariens 920403 - Sno-Tek 28E Manual del operador

Quick Start Guide Sno-Tek 28E (920403 s/n 35000 - 74999) • Step 1: Unfold Handlebar • Step 2: Install Discharge Chute • Step 3: Install Discharge Chut

IMPORTANT: The engine is shipped with 5W-30 oil in crankcase. Refer to engine manual for detailed instructions. Step Eight: Check Engine Crankcase Oil

Fill fuel tank. DO NOT OVERFILL! See FILLING FUEL TANK in Owners Manual. Step Nine: Fill Engine Fuel Tank

Step Ten: Starting the Engine

Starting Engine / Step A: Choke Turn choke ON.

Starting Engine / Step B: Rocker Switch Push rocker switch to RUN position.

Starting Engine / Step C: Fuel Shut Off Valve Turn fuel shut off valve to “ON” position.

Starting Engine / Step D: Key Install safety key switch. Insert ignition key into slot but DO NOT turn the key. Be sure ignition key snaps into place.

Starting Engine / Step E: Prime Prime system: 3 primes maximum. DO NOT over prime system. Make sure you cover the vent hole before the primer is comp

Starting Engine / Step F: (Manual Start) Grasp rope handle. Pull slowly until resistance is felt, then pull rope firmly and quickly to start engine a

Starting Engine / Step F: (Electric Start) Use a 3-wire extension cord and plug cord into starter motor adaptor first. Then plug cord into w

Step One: Unfold Handlebar 1. Remove the lower and loosen the upper hardware on the handlebar assembly. 2. Loosen the hardware on the shift rod. 3. Pu

Starting Engine / Step G: (Electric Start) Press and hold starter button. Note: Do not hold the electric starter button down for more than 5 seconds.

Starting Engine / Step H: Warm up Allow the engine to warm up for several minutes. Then, slowly move the choke control knob to the run position.

Step Eleven: Stopping the Engine To stop engine in an emergency, push the rocker switch to the STOP position. Under normal conditions: 1. Push rocker

Additional Resources • Refer to Owners Manual and Engine Manual • Contact Ariens Company www.ariens.com Phone: 920-756-4688 E-mail: [email protected] •

Step Two: Install Discharge Chute 1. Remove mounting hardware from the bottom of the chute pedestal mount. 2. Install discharge chute over opening in

Step Three: Install Discharge Chute Crank 1. Slide chute crank through support bracket. NOTE: Be careful not to damage nylon bushing when attaching c

Step Four: Install Remote Deflector Cable 1. Slide cable through clip on top of discharge chute pedestal 2. Bend clip closed around cable. 3. Using t

Step Four: Install Remote Deflector Cable Cont. 6. Position rubber seal cap over the top of snap fitting. 7. Move deflector control lever to rear mos

Step Five: Check Function of Dual Handle Interlock Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever

Step Six: Check Tire Pressure Check tire pressure and adjust to the pressure listed on tire sidewall.

Check oil level in auger gearcase (see Check Auger Gearcase in Owners Manual). Step Seven: Check Auger Gearcase Oil