Ariens 22-Ton Log Splitter Especificaciones descargar pdf (Pagina 23)

Do not attempt to operate the log splitter without fully understanding

all our instructions, safety precautions, and/or warnings. If any doubt

or question arises about the correct or safe method of performing any-

thing found in this or other Iron & Oak Products’ manuals, contact your

Iron & Oak Products’ dealer or call the Sales and Service representatives at our

main headquarters. Proper care is your responsibility.

When operating the log splitter, make sure you

are standing in the safe operating area, as

shown in these pictures. You must stay in the

safe operating area at all times when the

splitting wedge is in motion (whether extend-

ing or retracting). Never place any part of your

body into a position that causes an unsafe

operating condition.

1. Set your log splitter on flat, dry ground.

Make sure you read all the recommenda-

tions from the “Safety” section before

using the log splitter.

2. Make sure both ends of the log you are

splitting are cut as square as possible.

This will prevent the log from sliding out of

position while under pressure. All logs

should be 24 inches long or shorter.

Never attempt to split wood across the

grain. The log splitter was not designed for

cross-grain splitting. Doing so will dam-

age the log splitter and may cause person-

al injury.

WARNING

815-672-8596 21 Iron & Oak

Operation

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Sin comentarios

Ariens 22-Ton Log Splitter Especificaciones Pagina 23